Opel Corsa: Vehicle checks / Diesel fuel system bleeding. Wiper blade replacement
Diesel fuel system bleeding
If the tank has been run dry, the diesel
fuel system must be bled. Refuel at
least five lieter diesel. Switch on the
ignition for about 60 seconds and
switch off again. Then crank the
engine. If the engine does not start
directly, repeat this process a few
times. If the engine then fails to start,
seek the assistance of a workshop.
Wiper blade replacement
Note
Individual heating functionalities,
such as heated seats or heated
steering wheel, may be temporarily
unavailable in the event of electrical
loading constraints...
Switch off ignition.
Within one minute after switching off
ignition, operate the wiper lever to
position the wiper blades vertically on
the windscreen...
Other information:
Locks
The locks are lubricated at the factory
using a high quality lock cylinder
grease. Use a de-icing agent only
when absolutely necessary, as this
has a degreasing effect and impairs
lock function. After using a de-icing
agent, have the locks regreased by a
workshop...
In the following situations, the system
may not operate properly or even not
operate at all:
poor visibility caused by
inadequate lighting of the
roadway, falling snow, heavy
rain, dense fog etc.
dazzle caused by headlamps of
an oncoming vehicles, low sun,
reflections on damp roads,
leaving a tunnel, alternating
shade and light etc...