Opel Corsa: Driving and operating / Manual transmission

To engage reverse on 5-speed
transmission, depress the clutch
pedal and move the selector lever to
the right and rear.

To engage reverse on 6-speed
transmission, depress the clutch
pedal, pull the ring under the selector
lever and move the selector lever
quite to the left and front.
If the gear does not engage, set the
selector lever to neutral, release the
clutch pedal and depress again. Then
repeat gear selection.
Do not slip the clutch unnecessarily.
When operating, depress the clutch
pedal completely. Do not use the
pedal as a foot rest.
When clutch slip is detected for a
specific time, the engine power will be
reduced. A warning is displayed in the
Driver Information Centre. Release
the clutch.
Caution
It is not advisable to drive with the
hand resting on the selector lever.
Fault
In the event of a fault,
illuminates
a message is displayed in the Driver
Information Centre.
Electronic transmission control
enables only third gear...
Other information:
Turn key:
0 : ignition off: some functions
remain active until key is
removed or driver's door is
opened, provided the ignition was
on previously
1 : ignition on power mode: ignition
is on, diesel engine is preheating,
control indicators illuminate and
most electrical functions are
operable
2 : engine start: release key after
engine has been started
Steering wheel lock
Remove key from ig..
Caution
Do not attach heavy or bulky items
to the ignition key.
Replacement keys
The key number is specified on a
detachable tag.
The key number must be quoted
when ordering replacement keys as it
is a component of the immobiliser
system.
The code number of the adapter for
the locking wheel nuts is specified on
a card. It must be quoted when
ordering a replacement adapter.
Key with foldawa..