Opel Corsa: Starting and operating / Starting the engine
Vehicles with ignition switch

Turn key to position 1 to release the
steering wheel lock.
Manual transmission: operate clutch
and brake pedal.
Automatic transmission: operate
brake pedal and move selector lever
to P or N.
Do not operate accelerator pedal.
Diesel engines: wait until control
indicator
extinguishes.
Turn key briefly to position 2 and
release after engine has been
started.
Manual transmission: during an
Autostop, the engine can be started
by depressing the clutch pedal.
Automatic transmission: during an
Autostop, the engine can be started
by releasing the brake pedal.
Vehicles with power button

- Manual transmission: select
neutral gear, operate clutch and
brake pedal.
- Automatic transmission: operate
brake pedal and move selector
lever to P or N.
- Do not operate accelerator pedal.
- Press Start/Stop button.
- Release button after starting
procedure begins. Diesel engine
starts after control indicator
for preheating extinguishes.
- Before restarting or to switch off
the engine when vehicle is
stationary, press Start/Stop once
more briefly.
To start the engine during an
Autostop:
- Manual transmission: during an
Autostop, the engine can be
started by depressing the clutch
pedal.
- Automatic transmission: during
an Autostop, the engine can be
started by releasing the brake
pedal.
Emergency shut off during driving
If the engine needs to be switched off
during driving in case of emergency,
press Start/Stop for 5 seconds.
Danger
Switching off the engine during
driving may cause loss of power
support for brake and steering
systems. Assistance systems and
airbag systems are disabled.
Lighting and brake lights will
extinguish. Therefore power down
the engine and ignition while
driving only when required in case
of emergency.
Starting the vehicle at low temperatures
Starting the engine without additional
heaters is possible down to -25 °С for
diesel engines and -30 °C for petrol
engines. Required is an engine oil
with the correct viscosity, the correct
fuel, performed services and a
sufficiently charged vehicle battery.
With temperatures below -30 °C the
automatic transmission requires a
warming phase of approx. 5 minutes.
The selector lever must be in position
P.
Turbo engine warm-up
Upon start-up, engine available
torque may be limited for a short time,
especially when the engine
temperature is cold. The limitation is
to allow the lubrication system to fully
protect the engine.
The electronic key or smart access
device must be inside the vehicle.
Engine start
Operate the clutch pedal (manual
transmission), the brake pedal and
press Start/Stop...
Overrun cut-off
The fuel supply is automatically cut off
during overrun, i.e. when the vehicle
is driven with a gear engaged but
accelerator pedal is released...
Other information:
The following instrument cluster is
available:
Overview
Turn lights
Seat belt reminder
Airbag and belt tensioners
Airbag deactivation
Charging system
Malfunction indicator light
Service vehicle soon
Stop engine
System check
Brake and clutch system
Electric parking brake
Automatic operation of electric
parking break off
Electric parking brake fault
Antilock brake system (ABS)
Gear..
The forward collision alert may help to
avoid or reduce the harm caused by
front-end crashes.
The forward collision alert uses the
front camera in the windscreen and
depending on the vehicle
configuration a radar unit located
behind the front bumper to detect a
vehicle directly ahead, in the path.
If a vehicle directly ahead is
approached too quickly, a warning
chime sounds and a message..